How to debug the stage professional audio.Bar audio company

　　The high level of the stage professional audio is very high. Many times, the debugging is not good, and the effect of the desire is not achieved, so many audiors consult us how to debug the stage professional audio. Today, senior engineers will talk about this issue. The debugging work of the stage professional audio project needs to be treated with a serious and responsible attitude. Only after the design, construction, system structure and equipment performance are fully understood can they get a better debugging result. For general debugging work, it often occurs in general debugging work. The question of several stage professional audio adjustment should be introduced to you for your reference.

　　① Before debugging, we must carefully understand the performance of the system structure and equipment, because only by fully grasping the situation of the system and equipment, we formulate a feasible debugging solution based on the actual situation to estimate the possible situation during debugging. Otherwise , I do n’t know if I do n’t know about the system and equipment. I do n’t know myself. Especially for some new and special equipment we rarely use in general projects, we must study its principles, performance, and operation methods carefully before installing and commissioning.

　　② Before debugging, we must conduct a comprehensive inspection of the setting of the system and equipment. Because the focus of installation and stand -alone inspection process and system debugging are different, after all, the setting of the equipment is often casual. Some important set buttons may be completely different from the actual requirements before debugging. It is best to record the setting of each equipment.

　　③ The corresponding debugging method should be adopted according to the characteristics of the system. Because the system indicators of the audio lighting engineering may be different, the equipment involved is not the same. If the general engineering debugging method is made, the result will not be ideal. For example: a sound system without feedback suppressor. If you do not refer to the design results during debugging, you can find the feedback point by looking for the feedback point only for a long time high -gain sound expansion, which may cause the speaker to damage.

Read recommendations:

C10 Sound bar manufacturer

A28 CARDIOID SUBWOOFER Learning audio Merchant

MB210 Low Profile Bar audio set Merchant

How to tune?Audio equipment for ktv

Hohhot ID-X CLUB bar audio equipment--Mateng Audio